Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Table of Contents

Introduction

...

  1. Ensure that the Yes, save results in user record LQA option is enabled in the Workflow editor, for the step in which LQA evaluation is to be performed.

...

    ...

    1. Ensure that the LQA-preceding step is fully performed by the assigned linguist (LQA-related segments must be manually confirmed so that they have green status in XTM Workbench).

    ...

      ...

      1. Ensure that the very LQA step is fully performed by the assigned linguist (LQA-related segments must be manually confirmed so that they have green status in XTM Workbench).

      ...

      1. Ensure that both linguists (Translator and LQA reviewer) stay assigned to the relevant steps after finishing the LQA step. If either of them are missing at that time, the LQA report will not be generated.

      ...

      Note

      IMPORTANT!

      If all the cases described above have been verified, but the issue still occurs, create a support ticket for the XTM International Support team and provide all the details needed for investigation.

      ...

      1. Ensure that the LQA reviewer imposes errors on the segments that were modified by the linguist in the step before LQA. If LQA errors are added to the segments that were not affected in the previous step, they will not be displayed in the report since they are out of the evaluation scope.

      2. Ensure that the actual linguist assigned to the task has entered XTM Workbench and modified the segments. It might be the case that, although the LQA report that was generated had the first linguist's name assigned to it (the linguist to whom the task was assigned), the LQA errors created in the LQA step were allocated with the statistics that were saved for the second linguist, so they were not included in the LQA report that evaluated the first linguist.

      ...

      1. In other words, the fact that another linguist was also working on this project caused issues with statistics. As a result, LQA errors were calculated incorrectly.

      ...

      For LQA report and errors to be generated correctly, XTM Workbench must be opened by the correct linguist, to whom the step has been assigned. If there are any errors then LQA will not be calculated correctly, as shown in the case above.

      ...